Cartridge:

  • Canon PG-210 or PG-210XL
  • Canon PG-240 or PG-240XL
  • Canon PG-243
  • Canon PG-245 or PG-245XL
  • Canon PG-260 or PG-260XL

Type: Sponge

Ink Volume:

  • PG-210/240/243/245/260 – 10ml
  • PG-210/240/243/245/260/XL – 18ml

Cartridge Color: Black

Materials Required

  • Empty or Partially Filled Cartridge
  • Black Refill Ink
  • Drill Tool
  • Disposable Glove
  • Paper Towel
  • Syringe and Needle
  • Printhead Cleaning Wipes

1. Before beginning, ensure that the cartridge is refilled on top of a non-absorbent, easy to clean material (like a sink).

2. Partially remove the identification label from the top of the cartridge until all the holes are revealed as in the provided reference picture below. Do not discard.

3. Position the included drill tool over any of the 16 inlets (they all lead to a central, single ink chamber) or over the air hole on the XL cartridge. For reference, we drilled the third hole from the top as it is closest to the printhead.  Slowly turn the included drill bit tool in a forward and reverse motion until the resulting hole is sufficiently large for the needle.

4. Fill the syringe with the proper amount of ink (see above reference chart). For a standard 5cc syringe, you may need to fill it up to 4 times. (Note: 1ml = 1cc)

5. Insert the needle no more than an inch into the hole as shown in the picture reference. Avoid wiggling or shaking the needle during this process to reduce potential damage to the cartridge. Once inside, slowly inject the ink as to make sure that it does not overflow due to residual ink on the cartridge sponge. If the ink begins to spill out from the top of the cartridge pull the syringe back ½ ml and stop.

6. It is normal for the printhead to drip excess ink for a short time. During this period do not allow the printhead to have direct contact with an absorbent material such as a paper towel as this will cause the cartridge to continue leaking. Wait until the dripping has ceased before dabbing off excess ink from the printhead with a soft cloth or a towel.

7. Use the provided Printhead Cleaning Wipes to clean the bottom of the cartridge. If you run out of the provided wipes, you may use a damp cotton cloth with water or rubbing alcohol to achieve a similar result.

8. Seal the top of the cartridge using the original identification label. Do not cover the air hole with tape.

9. Insert the cartridge back into the printer. It is normal for the printer to display a low ink notification after the refill process, as this sensor is based on the number of pages printed and not the actual ink capacity of the cartridge.

10. Perform a nozzle check pattern to settle the cartridge and test for printing irregularities. Alternatively, you may print a color picture or a black text document to test the  color or black cartridge, respectively. It is also recommended to run the Alignment Tool or Cleaning Tool from the printer. Most printers with an LCD display will have this option available in the settings menu. Printers without a display will generally have this setting under Printer Preferences/Settings from the PC/Mac.

11. If you are having trouble with the refill kit please refer to our comprehensive troubleshooting guide or contact us by SUBMITTING A TICKET (Click Here).